中空玻璃的應用在不斷的擴大，人們對中空玻璃的質量要求也越來越高，提供優良可靠的中空玻璃已成為中空玻璃生產廠家研究的問題。每一道中空玻璃都是需經過重重測試，嚴格把關才能出成品。下面小編給大家總結一下中空玻璃常見的檢測指標，希望對大家有所幫助！
The application of hollow glass is expanding, and people have higher and higher requirements for the quality of hollow glass. Providing high quality and reliable hollow glass has become a research issue for manufacturers of hollow glass. Every insulating glass has to undergo heavy testing and strict checks to produce the finished product. The following small edition summarizes the common detection indicators of hollow glass, hoping to be helpful to you all! 
1、初始露點：測試中空玻璃內空氣是否干燥，國標規定露點等于或低于-40度為合格。
1. Initial dew point: To test whether the air in the hollow glass is dry or not, the national standard stipulates that dew point equal to or below - 40 degrees is qualified.
2、紫外線照射：測試中空玻璃密封膠是否含有影響視線的有機揮發物。中空玻璃樣品經300W紫外燈連續照射168h后，在23±2℃的溫度下存放一周，中空玻璃內表面不應出現霧狀、油狀或其他污染物。
2. Ultraviolet irradiation: test whether the hollow glass sealant contains organic volatiles that affect the sight. Hollow glass samples were irradiated by 300 W ultraviolet lamp for 168 hours and stored for one week at a temperature of 23 2 C. The inner surface of hollow glass should not be foggy, oily or other contaminants.
3、密封檢驗:測試中空玻璃密封膠的軟硬程度，以及是否存在泄露。樣品在低于環境氣壓10±0.5KPa的條件下保持2.5h，厚度增長偏差<15%為合格。
3. Sealing inspection: testing the degree of hardness and softness of insulating glass sealant and whether there is leakage. Samples were kept for 2.5 hours under ambient pressure of 10 +0.5 KPa, and the deviation of thickness growth < 15% was qualified.

4、高溫高濕試驗:主要測試密封膠的粘結力、水氣透過率及分子篩的有效吸附能力是否達到標準要求。樣品在高溫高濕試驗條件下（濕度>95%，溫度在25-55℃之間有規律的變化）進行224個循環。每一個循環中空玻璃內的氣體都要經過一次膨脹和收縮，這樣對密封膠的粘結力就有較高的要求。另外，由于濕度較大，密封膠的水汽透過率應較低，而分子篩要有較強的吸附能力。
4. High temperature and humidity test: mainly test whether the bonding force, water vapor permeability and effective adsorption capacity of molecular sieve meet the standard requirements. Under the conditions of high temperature and high humidity (humidity > 95%, temperature changing regularly between 25-55 C), 224 cycles were carried out. The gas in each circulating hollow glass has to undergo expansion and contraction once, so the bonding strength of the sealant has a higher requirement. In addition, because of the high humidity, the water vapor permeability of sealant should be low, and molecular sieves should have strong adsorption capacity.
5、氣候循環試驗:這是一項耐老化試驗，是對中空玻璃綜合性能的考察。它模擬一年中的四季氣候（冷、熱、風、雨），每個循環都要經過加熱、自然冷卻和強制冷卻三個階段，共進行320個循環，檢驗中易出現問題是中空玻璃炸裂、開膠和終露點升高。
5. Climate Cycle Test: This is an aging test and an investigation of the comprehensive properties of hollow glass. It simulates the four seasons of the year (cold, hot, wind and rain). Each cycle goes through three stages of heating, natural cooling and strong refrigeration. A total of 320 cycles are carried out. The prone problems in the test are cracking of hollow glass, gel breaking and elevation of the final dew point.
隨著國內玻璃加工行業的發展以及人們對中空玻璃的優異性能認識的不斷深入，中空玻璃的應用范圍在不斷擴大，除在玻璃幕墻、汽車、飛機等方面得到廣泛應用外，目前已開始進入尋常百姓家。
With the development of glass processing industry in China and the deepening of people's understanding of the excellent properties of hollow glass, the application scope of hollow glass is expanding. Besides the wide application in glass curtain wall, automobile, aircraft and so on, hollow glass has begun to enter ordinary people's homes.
本文的精彩內容就先到這里了，了解更多關于中空玻璃的詳細情況可關注：http://www.txxfj.com
Here's the highlight of this article. For more details about hollow glass, please pay attention to http://www.txxfj.com.